Titebond Fast Set Polyurethane Construction Adhesive
Titebond Fast Set Polyurethane Construction Adhesive
Titebond® Fast Set Polyurethane Construction Adhesive is a one-component, advanced adhesive technology designed to build strength faster than other comparable products. It can be used for interior and exterior construction projects, and is the highest performing product of its kind, offering unmatched strength and durability even when bonding non-porous materials. It offers a fast set-up time as well as a smooth bead for effortless extrusion – even in near-freezing temperatures. It is ideal for virtually all building materials, including wet, frozen, engineered and treated lumber, metal, plastic, foam, mirror, concrete and brick.
NEW PRODUCT ENHANCEMENTS'
- Faster set time and cure – develops strength quicker than common construction adhesives
- Permanently bonds most building materials
- Cold weather extrusion – extrudes down to 00C
- Provides a smoother, more full-bodied adhesive bead that offers minimal shrinkage
TITEBOND FAST SET POLYURETHANE ADHESIVE EXCEEDS ALL OF THE FOLLOWING SPECIFICATIONS: AMERICAN PLYWOOD ASSOCIATION AFG-01, ASTM C557, ASTM D3498, CAN/CGSB-71.25M AND CAN/CGSB-71.26M
Product Features
- Environmentally safe - VOC-compliant
- Advanced urethane formula
- Ideal for use on wet, frozen, treated and engineered lumber
- Unmatched strength and durability
- Can be used to bond non-porous materials
- Works in near freezing temperatures
- Safe for plastic or foam
- Fast initial grab - Smooth bead - Fast cure - Minimal shrinkage
- Cartridge and carton contain post-consumer recycled material
Physical Properties
Color: Brown
Solids: 98%
Viscosity: 150,000 cps
Freeze/thaw Stability: Will not freeze
Calculated VOC: 20g/L
Flashpoint: >940C
COVERAGE (MAXIMUM): APPROXIMATE LENGTH OF BEAD ACCORDING TO BEAD DIAMETER: ~ 6mm -9,5m, 9mm -4,3m, 13mm –2,5m
Application Guidelines
Application Temperature: nuo 00C iki +490C
Service Temperature Range: nuo -290C iki +490C.
Open Time: 15-20 minutes at 50% relative humidity
Working Time: Approximately 1 hour
Working Surfaces: Surfaces to be bonded should be clean and free from excessive oil, grease, water, dirt or any other material that may deter adhesion. Apply adhesive to only one of the surfaces to be bonded. NOTE: When bonding subfloors or wet, frozen and treated lumber, nail or screw each sheet as recommended by the American Plywood Association.
Cleanup: Scrape off dried excess with a putty knife. Remove residue with mineral spirits or equivalent solvent. Follow solvent vendor's precautions when using solvents. NOTE: Test solvent on an out-of-the-way area to make sure it will not mar or attack the surface.
Limitations:
Titebond® Fast Set Polyurethane Construction Adhesive is not designed for continuous submersion. Adhesive can be difficult to remove from skin and clothing. It is recommended that gloves be worn. When using on non-porous substrates, mist with water to speed curing.
WARNING: EYE AND SKIN IRRITANT. Potential skin and respiratory sensitizer. Contains isocyanates containing polymers. Avoid prolonged or repeated contact with skin or vapors. Do not allow eye contact. Use only with adequate ventilation. First Aid: If skin contact occurs, wash affected area with soap and water. If irritation persists or allergic reactions develop, contact physician. If adverse respiratory affects occur, remove individual to fresh air and contact physician. If eye contact occurs, flush eyes with water for 15 minutes; contact physician. If swallowed, do not induce vomiting; contact physician. For additional information, refer to Safety Data Sheet. KEEP OUT OF THE REACH OF CHILDREN.
